Connecting The Cables - Samsung SCC-C4205 Guia Del Usuario

Connecting the Cables

1. Connect one end of the BNC cable to the VIDEO OUT.
2. Connect the other end of the BNC cable to the VIDEO IN
of the monitor.
Video terminals on the back
of the monitor
BNC cable
3. Plug in the power adapter. Use a "minus" screwdriver to
connect one part of the power adapter, which consists of
two lines, to the POWER terminal of the camera as follows :
POWER SELECTION
switch underneath the
power adapte
13
All manuals and user guides at all-guides.com
REMOTE RS-485 PWR IN
POWER SELECTION switch
underneath the power adapte
REMOTE RS-485 POWER
4. Determine the type of power supply and set the POWER
SELECTION switch accordingly. Next, plug the power
adapter into a wall outlet.
The requirements for the power adapter for each model are
as follows:
G SCC-C4205(P) : DC12V 600mA
G SCC-C4305(P) : AC24V 300mA
DC12V 600mA
5. If the camera operates normally, the following screen will
be displayed for 5 seconds and then disappears.
PROTOCOL
ADDRESS
TYPE
BAUD RATE
LENS
EEP VER
ROM VER
6. The requirements for RS485 control is as follows :
G
Signaling Speed: 9600 bps
G
Data Bit : 8 bits
G
Stop Bit : 1 bit
G
Parity Bit : none
SAMSUNG
0
RS-485, HALF
9600
OK
1.0
1.0
E
14