SOMFY LT 50 CSI Guia De Instalacion página 12

EN
CONTENT
2.1. General safety advice
2.3. Operating conditions
3.1. Motor preparation
3.2. Tube preparation
3.3. Motor/tube assembly
3.4. Fitting the adjustment pull tabs (optional)
3.5. Fitting the emergency crank
3.6. Fitting the motorised tube
3.7. Wiring
4.1. Checking the direction of rotation
4.2. Adjusting the end limits with the momentary action-type switch
4.4 Checking the settings
4.5 Fitting the protective housing
5.1 Operating the control point
5.2. Operating the emergency crank
1. INTRODUCTION
The LT 50 CSI and LT 60 CSI motors are designed to drive roller shutters and awnings.
They are equipped with a back-up system used to open and close the roller shutters and awnings in the
event of a power cut: the roller shutter or awning can be manually opened and closed using a special
integrated crank.
The upper and lower end limits of the motor can be adjusted using push-buttons. The push-buttons are
covered by a protective housing which ensures the motor head is sealed when installed outdoors with the
push-buttons facing upwards.
12
Copyright © 2007-2016 Somfy SAS. All rights reserved.
LT 50 CSI - LT 60 CSI
13
13
13
13
14
14
14
14
14
15
15
17
17
18
18