SOMFY LT 50 CSI Guia De Instalacion página 15

LT 50 CSI - LT 60 CSI
- Remove the protective housing.
- Press simultaneously on the white and yellow push-buttons
to operate them.
- Switch on the power supply.
- Press the "Up" switch at the control point:
- If the roller shutter or awning rises, the wiring is correct:
move onto the section entitled "Adjusting the end limits".
- If the roller shutter or awning lowers, the wiring is not
correct: move onto the next step
- Switch off the power.
- Reverse the brown wire and the black wire on the control
point.
- Switch the power supply back on.
- Press the "Up" button on the control point to check that the
roller shutter or awning rises.
- Lower the roller shutter or awning to the required lowered
position by pressing on the «Down» button on the control
point.
- Release the «Down» button when the roller shutter or
awning reaches the required lowered position.
- Looking at the motor head end-on:
- If the roller shutter or awning lowers from the right-hand
side of the head, press the yellow button to unlock it: the
lower end limit is set.
- If the roller shutter or awning lowers from the left-hand
side of the head, press the white button to unlock it: the
lower end limit is set.
Copyright © 2007-2016 Somfy SAS. All rights reserved.
EN
1 2 3 4
N
15