Zipro Dynamite Manual De Uso página 20

•
Do not use the product close to a wall. The safety zone is 2000 mm long and not narrower than the
device.
CAUTION! Be careful during the assembly and do not let children near the assembly area. They may ingest
small parts used during the assembly (nuts, bolts, etc.).
RESIDUAL RISK
•
Only 13 out of over 230 causes are 'generally acceptable' following risk controls.
•
If no fall safeguard is applied or it is applied incorrectly, there is a residual risk of falling resulting in
skin abrasions, bruises, bone fractures, or even death.
• There is a residual risk of unintended over-exercising caused by incorrect operation or judgement,
and also incorrect communication (due to electromagnetic interference, software error, etc.). Even
the best software and equipment safeguards cannot prevent software or equipment errors, which
can, in theory, cause over-exercise.
•
The product is an electric device. Therefore, electric shock, potentially leading to death, is possible.
•
The residual risk of suffocation cannot be prevented.
•
It can be mitigated by following safety information in the operating manual.
• Unintended or prohibited use may cause other risks not specified here. The specified risk may have
been estimated incorrectly.
The risk analysis assessment has been performed on the device 'as is'. The product assessment and
control intricate that the probability of unacceptable risk is very low. The device (its design, operation,
and use) does not cause unreasonable risk for the user or third parties under normal circumstances.
TRANSPORT PACKAGING HANDLING MARKS
This side up. Do not tip over.
Fragile. Prone to damage. Proceed with caution.
Handle with care.
Protect from humidity.
Recyclable packaging.
Attention, heavy product.
OPERATION
Make sure the device has been assembled correctly before starting the training.
•
Before your first training, get familiar with all the functions and adjustments available for the device.
• Some parts of the device may corrode. It is, therefore, inadvisable to leave the device in a room with
a high moisture content. Take care not to allow the device (in particular internal and electronic
components) to be exposed to water, beverages, sweat, etc.
EN
20