Ega Master MASTEREX 79989 Manual De Instrucciones página 37

Requirements to the air supply
The pneumatic circular saw works optimally at an operating pressure of 6 bar, measured at
the air inlet.
The distance from the air supply to the machine has to be adjusted to the application
conditions on site.
We recommend installing an oiler or a maintenance unit in the airline for compressed
air preparation. Use acid and resin-free lubricating oil, like SAE 5W - SAE 10W, for proper
functioning of the pneumatic circular saw. Attention! Do not use viscous oil.
Use an antifreeze lubricant, e.g.:
- "Kilfrost"
- or "Kompranol N74" in winter and if the compressed air is very moist.
IDENTIFICATION
INSTALLATION
37