Warranty And Liability - Ega Master MASTEREX 79989 Manual De Instrucciones

The following table shows possible problems and their causes:
Problem
a Machine does not start
Machine is rotating too
b
c
Gear makes loud noise
d Other problems
If necessary, we ask you to send the machine to the supplier.
Unless otherwise specified, our "General Sales Terms" apply. Warranty and liability claims in
regards to persons or equipment damages are invalid, if one or several of the following causes
apply:
• Improper use of the machine.
• Improper assembly, startup, operation or maintenance of the machine.
• Operation of the machine with defect safety devices or improperly fixed or non-functioning
safety and protection devices.
• Non-observance of the instructions in the operating instruction booklet concerning transport,
storage, assembly, startup, operation, maintenance and setting up of the machine.
• Independent structural alterations or settings on the machine beyond the intended purpose
• Inadequate supervision of wear parts.
• Improperly carried out repairs, inspections or maintenance
• Catastrophic cases because of a war, acts of god or other reasons which are beyond our
control.
52
TROUBLESHOOTING
Operating pressure too low
Hose diameter too small
slowly

WARRANTY AND LIABILITY

Cause
Not connected to
compressed air
Flow rate too low
-
-
Remedy
Connect and open the supply
line
Increase operating pressure
Choose larger hose diameter
Increase flow rate
Contact authorized expert
company
Contact authorized expert
company