Ega Master MASTEREX 79989 Manual De Instrucciones página 38

The supplied compressed air has to be free of:
- Foreign particles,
- humidity.
Pay attention that all hoses:
- Have a cross section being large enough,
- do not have any restrictions or kinks,
- are designed for a minimum operating pressure of 6 bar,
- are replaced regularly at preventative maintenance,
- have an oil resistant inner surface and an abrasion-resistant outer surface,
- are proved and specified to be non-conductive when being used next to electric conductors.
Always use hoses, lubricating oil and antifreeze lubricants, which meet the local safety
requirements for use in areas exposed to explosion hazards.
Connecting the air supply to the pneumatic circular saw
Remove the locking cap from the air connection item 3 (see fig. 2). Connect the pneumatic
hose (not contained in the scope of delivery).
When connecting the machine, pay attention not to actuate the valve trigger item 2 (see fig.
2). Blow out the pneumatic hose before connecting the machine. Never connect a pressurized
pneumatic hose (see safety instructions for prevention of hazards caused by compressed air).
Always connect the machine first and then switch on the pneumatic supply.
Installing the blade
- Disconnect the machine from the pneumatic supply.
- Remove any accumulated chips.
- Check the bottom guard to ensure that it is functioning properly.
- Clean the inner centering flange.
- Mount the saw blade with the correct holder diameter and ensure that the teeth point to the
correct direction. (If there is any doubt regarding the alignment of the saw blade, refer to the
specification of the saw blade guard.)
38
Fig. 2
STARTUP