System; Status - Devolo 5400 Manual

If a DHCP server is already present on the network
for assigning IP addresses (e.g. your Internet rou-
ter), you should leave the Retrieve network set-
tings from a DHCP server option enabled so that
the WiFi 6 Repeater 5400 automatically receives
an address from it.
If you want to assign a static IP address, make
entries accordingly for the Address, Subnet mask,
Default gateway and DNS server fields.
Confirm your settings by clicking the Disk icon.
Then, restart the adapter (see Chapter 4.7.3 Confi-
guration) to ensure that your changes take effect.
IPv6 configuration
Address: Shows the IPv6 address that the device
uses to reach the internet.
Subnetmask (Prefix): Shows the length of the pre-
fix in bits. The prefix is the front bit of the of the
IPv6 address.
Example: 2a00:fe0:313:25:f606:8dff:fe4f:6aee
with prefix 64 means that the prefix here is
2a00:fe0:313:25.
Network configuration 46

4.7 System

In the System area, you can configure the settings
for security and other device functions.

4.7.1 Status

Here you can view the most important information
on the device, including the current date and time,
time zone, MAC address of the adapter, status of
the Wi-Fi LED and the operating button.
devolo WiFi 6 Repeater 5400