cecotec CONGA ROCKSTAR 700 ULTIMATE ERGOWET Manual De Instrucciones página 20

ENGLISH
the suction base matches the guides on the tube, and introduce one into the other until they
are firmly fixed. To disassemble them, press the suction base release button and pull from
the vacuuming tube while you hold the suction base.
Fig. 2
Note: when assembling these 2 parts, make sure the handle and the brush are facing the
same direction.
Use the Flex tube to reach and clean the most difficult areas and dirt. To bend the tube, press
the Flex button.
Battery and handheld vacuum cleaner assembly
Introduce the battery in the slot located in the handheld vacuum cleaner. Once it is
introduced, move it slightly to ensure it is properly assembled in place.
Fig. 3
Following the below illustration, keep the vacuuming tube vertically, align the tab on the
vacuuming tube with the guides in the handheld vacuum cleaner and introduce the tube.
Dust tank and handheld vacuum cleaner
To assemble the dust tank to the handheld vacuum cleaner, first separate the handheld
vacuum cleaner from the vacuuming tube.
Then, press the vacuuming tube release button with one hand and, holding from the handle
with the other one, turn the dust tank anticlockwise to the unlock position indicated on the
dust tank edge.
To disassemble the dust tank, turn it clockwise until it reaches the unlock position.
Fig. 4
Suction base, vacuuming tube and handheld vacuum cleaner installation
To complete the full installation of the device, hold the vacuuming tube with the suction base
assembled upright and introduce the tube in the handheld vacuum cleaner as shown on the
illustration.
Fig. 5
4. OPERATION
Handheld vacuum cleaner
Once the handheld vacuum cleaner has been disassembled from the vacuuming:
Press the On/off button to turn the device on.
Press the power push button to select the desired power level.
It will automatically operate in Eco mode. The power level can be adjusted at any moment by
pressing this button.
Press once to switch to Daily mode.
Press again to operate it at Turbo mode.
38 CONGA ROCKSTAR 700 ULTIMATE ERGOWET
Press the On/off button to turn the device off.
Fig. 6
Upright Vacuum Cleaner
Assemble the vacuuming tube (see section 3 "Product Assembly")
Press the On/off button to turn the device on.
Press the power push button to select the desired power level.
It will automatically operate in Eco mode. The power level can be adjusted at any moment by
pressing this button.
Press once to switch to Daily mode.
Press again to operate it at Turbo mode.
Press the On/off button to turn the device off.
The device includes Auto Carpet that is activated automatically when it detects a carpet or a
large amount of dirt.
Accessories
This device includes different accessories that allow cleaning different types of surfaces,
objects and dirt. Some of them are suitable for the upright vacuum cleaner, and others are
preferably used with the handheld one.
Jalisco brush
Assemble this brush to the upright vacuum cleaner. This brush is designed especially for
cleaning hard floors, but can be used to clean efficiently soft floors too. The brush counts
on a protection system that avoids tangles and prevents the device from being damaged. As
the brush stops rotating and the device stops operating automatically when it vacuums big
objects or excessive dirt.
Fig. 7
Motorised upholstery brush
This brush should be used with the upright-vacuum cleaner to clean all types of upholstery.
Silicone and bristles brush
Interchangeable brush made of silicone and bristles, ideal for cleaning carpets and pet hair.
This accessory is used with the upright vacuum cleaner.
Extensible tube
This accessory is a extensible tube that is fitted into the handheld vacuum cleaner and is
used as an adapter for the rest of accessories. It allows reaching less accessible areas.
2-in-1 wide brush for furniture and corners
This accessory is used with the handheld vacuum cleaner and allows cleaning furniture
CONGA ROCKSTAR 700 ULTIMATE ERGOWET
ENGLISH
39