Emptying The Tub; Cleaning And Maintenance - Lotus CP-74ET Instrucciones Para La Instalación Y El Uso

GB IE
EQUIPOTENTIAL
The appliance must be connected to an equipotential system. The connection screw is positioned at the back of the
appliance and is identified by the symbol.
Attention! The manufacturer will neither be held responsible for, nor will give any compensation during the guarantee
period for any damage caused, and which is due to inadequate installations not compliant with the instructions.
STARTING UP
Before using the appliance, it is necessary to clean it carefully, especially the tub (see paragraph "cleaning and care").
Check the connection of the appliance and start it up following the instructions.
INSTRUCTIONS FOR USE
Attention! Use the appliance only under surveillance.
- Never start up the appliance without water.
- The drip pan may only be opened when the appliance is cold.
With pasta cookers it is possible to cook pasta, vegetables, rice, eggs, legumes, etc.
TURNING ON
Check that the water drainage tap, which is situated in the compartment under the appliance (lever in horizontal
position) is turned off. Fill the tub with water (max.60°C), keeping the button of the filling electrovalve pushed down
--
until the level indicated by the symbol stamped inside the tub is reached. Switch on the switch situated above the
appliance. Turn the knob from "O" into the desired position between 30° and 110°; The white and green lights come on.
The green light indicates that the power supply is on.
The white light shows that the heating element is working; when the temperature is reached, it goes out. To turn off the
appliance, turn the knob into position "O".

EMPTYING THE TUB

To carry out this operation, it is necessary to open the outlet tap (lever in vertical position) which can only be reached
through the cabinet door situated below the appliance.

CLEANING AND MAINTENANCE

Attention! During cleaning, do not wash the external parts of the appliance with direct sprays of water or with
high pressure.
After every use, clean the appliance thoroughly. Daily cleaning after switching off the appliance ensures the perfect
functioning and long life of the appliance.
Before starting to clean the appliance, disconnect the power supply. The parts in steel must be washed with hot water
and neutral detergent, then rinsed thoroughly in order to eliminate all traces of detergent; after which, dried with a dry
cloth. Do not use abrasive or corrosive detergents.
Procedure to follow if the appliance is not going to be used for some time
Clean and dry the appliance carefully according to the instructions. Disconnect the power supply.
Procedure to follow in the event of a breakdown
In the event of breakdown, turn off the appliance, disconnect the power supply by using the device situated above the
appliance and notify the after sales service.
19