Setting The Sleep Function; Changing The Units Of Temperature; Using The Led Lights; Resetting The Remote Control - Webasto Cool Top Trail 28 Instrucciones De Uso Y De Instalacion

5 | Operating Instructions
l TIMER ON / OFF mode
In this mode the unit will start to run at the ON time and
stop running at the OFF time. This pattern will be repeated
every day.
Fig. 37 TIMER Modes
1. Press the TIMER button repeatedly until either the ON or
OFF or both symbols are flashing depending on which timer
mode is preferred.
2. To confirm the selection wait 10 seconds until the symbol
stops flashing and is shown permanently. The clock time is
now displayed again.
Fig. 38 Activating the timer
NOTE
If the clock is displayed without an ON / OFF icon, then
you have not activated the timer.
5.13

Setting the sleep function

The sleep function automatically modifies the target temperat-
ure to provide a comfortable sleeping temperature. This also
helps to reduce compressor run time, energy consumption and
noise levels.
1. Press the SLEEP button to activate the sleep function.
– The icon is displayed in the display of the remote con-
trol to indicate that the sleep function is activated.
– In COOL mode the set temperature will automatically in-
crease in two steps and it will have increased by 2 °C
after two hours.
– In HEAT mode the set temperature will automatically de-
crease in three steps and it will have decreased by 3 °C
after two hours.
– The sleep function is only available in COOL or HEAT
mode.
2. Press the SLEEP button again to deactivate the sleep func-
tion.
Fig. 39 Setting the sleep function
5.14

Changing the units of temperature

Press the °C/°F button to select which units of temperature
units you want to be displayed: Celsius or Fahrenheit.
l You can do this in any mode.
l The display on the air distributor follows the selection made
on the remote control.
14 / 136
Fig. 40 Celsius / Fahrenheit selection
5.15

Using the LED lights

NOTE
Function is only available for units with LED lights integ-
rated into the air distributor.
1. To turn on the LED lights on the air distributor, press the
LIGHT button. The LEDs illuminate the interior of the
vehicle.
2. When LED lights are on, you can adjust the LEDs' bright-
ness by repeatedly pressing the DIM button. The stepped
settings are: 25, 50, 75, and 100%.
3. To turn off the LED lights, press the LIGHT button again.
Fig. 41 LED lights on the air distributor
5.16

Resetting the remote control

To reset the remote control to factory settings:
1. Take out the batteries. and then put them back in. See also
chapter 6.2, "Remote control batteries" on page 15.
2. Set the clock again. See chapter 5.10, "Setting the system
clock" on page 13.
3. Activate the timer again, if in use. See chapter 5.12, "Activ-
ating the timer" on page 13.
Fig. 42 Resetting the remote control
9042924A OI-II CTT 28