Setting The Temperature; Setting The Fan Speed; Setting The Operation Mode - Webasto Cool Top Trail 28 Instrucciones De Uso Y De Instalacion

5 | Operating Instructions
l The display of the remote control shows only the clock.
You can also switch the unit on and off by pushing the touch
button at the air distributor, see chapter 5.17, "Operating the
air distributor without the remote control" on page 15 for de-
tails.
5.7

Setting the temperature

Use the / buttons to change the set temperature.
Fig. 27 Setting the temperature
l Both the display of the remote control and the display of
the air distributor show the set temperature.
l The air conditioner confirms receiving each set value
change with a beep.
l You can set the temperature between 16 and 30°C when
the unit is running.
l You cannot set the temperature in FAN
5.8

Setting the fan speed

Use the FAN button to set the fan speed level.
l The fan speed level directly influences the air flow volume.
l Each push on the FAN button changes the fan level in the
sequence as shown below.
AUTO indicates that the Automatic FAN mode is selected. In
this mode the fan speed adapts automatically. Automatic FAN
mode is only available in operation mode COOL or HEAT.
Fig. 28 Setting the fan speed
5.9

Setting the operation mode

Press the MODE button on the remote control to change the
operation mode. The remote control shows the selected icons
l Each push on the MODE button changes the mode in the
sequence as shown below.
Fig. 29 Setting the operation mode
COOL mode
l In COOL mode the air distributor shows the
the vehicle will be cooled.
l Set temperature and fan speed can be selected manually.
l The compressor switches off when the set temperature is
reached, it automatically switches on again when the room
temperature setting is exceeded.
12 / 136
Fig. 30 COOL mode
DRY mode
l In DRY mode the unit is reducing the humidity inside the
vehicle.
l Set the temperature 1 °C lower than the current room tem-
perature.
l The air distributor shows the
mode.
Fig. 31 DRY mode
FAN mode
l In FAN mode indoor air is circulated through the vehicle
without heating or cooling.
l You can manually set the fan speed.
l The air distributor shows the
room temperature.
Fig. 32 FAN mode
HEAT mode
l In HEAT mode the air distributor shows the
vehicle will be heated.
l You can manually set the temperature and fan speed.
l The compressor switches off when the set temperature is
reached, it automatically switches on again when the room
symbol and
temperature drops below the set point.
symbol.
icon as well as the current
icon and the
9042924A OI-II CTT 28