Fein Dustex 35 LX Manual De Instrucciones página 36

en
36
disposal, a disposal bag or fleece filter
bag must additionally be used.
When inserting, work the disposal
bag over the container rim. Pull the
other opening of the disposal bag
completely over the collar of the
vacuum socket.
To remove, work the disposal bag
up, and pull it out toward the rear via
the vacuum socket. Seal off the dis-
posal bag with the closing strip.
After vacuuming wet debris, always
remove the disposal bag.
When inserting a fleece filter bag,
take care that the closing cover and
the fleece filter bag face completely
against the inside wall of the con-
tainer. The cardboard flange of the
fleece filter bag must be pulled over
the collar of the vacuum socket.
After removing the fleece filter bag,
seal it with the closing cover in order
to avoid debris.
Audio signal (see page 12)
Only for FEIN Dustex 35 MX (**): Set
the selector switch for the vacuum-
hose diameter to the appropriate
value.
When the air velocity falls below
20 m/s, an audio signal will sound.
Empty the container and/or check
the vacuum system for clogs.
Vacuum cleaner socket outlet
(see page 11)
The switch position for switching the
vacuum cleaner on is shown on
page 11/12.
In switch position
cleaner automatically starts as soon
as the power tool connected to it is
switched on.
, the vacuum
Switch the vacuum cleaner off before
connecting a power tool to the vac-
uum cleaner's socket outlet. Make
sure that the power tool is switched
off when inserting its plug into the
vacuum cleaner's socket outlet.
After switching off a power tool con-
nected to the vacuum cleaner's
socket outlet, the vacuum cleaner
will run on for approx. 15 seconds
and then automatically switch off.
Wet vacuuming (see page 17)
When wet vacuuming electrically
conductive liquids, the vacuum
cleaner is automatically switched off
(automatic shut-off) when reaching
the maximum filling height of the
container. Pull the mains plug from
the socket outlet and empty the
container.
When wet vacuuming electrically
non-conductive liquids (e. g., oils,
drilling emulsions), the vacuum
cleaner is not automatically switched
off when reaching the maximum fill-
ing height of the container. Empty
the container in time.
Switch the vacuum cleaner off imme-
diately as soon as foam or water
comes out, and empty the container.
After completion of the wet vacu-
uming, clean the sensors and their
intermediate area using a brush (see
page 16).
Accessories (see page 9/20)
Mount accessories applying only
slight pressure. For disassembling,
turn the parts somewhat against each
other and pull apart.