All manuals and user guides at all-guides.com
3.
Install low pressure (black) nozzle
into quick connect fitting of spray
wand, see how To Use Spray
Wand paragraph in this section.
4.
After use of chemicals, place
detergent
siphon
container of clean water and draw
clean water through chemical
injection system to rinse system
thoroughly. If chemicals remain in
the pump it could be damaged.
Pumps damaged due to chemical
residue will not be covered under
warranty.
NOTE: Chemicals and soaps will not
siphon if the black soap nozzle is not
installed on the spray wand.
To Apply chemicals (BDX3100)
1.
Press detergent siphon hose
(F, Figure 19A) onto barbed fitting
located near high pressure hose
connection of pump as shown.
19A
f
2.
Fill
your
detergent
(L, Figure 19B) with pre-mixed
cleaning solutions designed for
pressure washer use.
19B
R
L
19C
L
3.
Place other end of detergent
siphon hose (F) with filter (R) on it
into detergent tank (L). Make sure
filter (R) is fully submerged into
cleaning solution.
NOTE: For every 7 gallons of water
hose
into
pumped 1 gallon of chemical/
cleaning solution will be used.
4.
Install low pressure (black) nozzle
into quick connect fitting of spray
wand, see how To Use Spray
Wand paragraph in this section.
5.
After use of chemicals, refill your
detergent tank with clean water
and operate your chemical injection
system to rinse it thoroughly. If
chemicals remain in the pump
it could be damaged. Pumps
damaged due to chemicals will not
be covered under warranty.
NOTE: Chemicals and soaps will not
siphon if the black soap nozzle is not
installed on the spray wand.
STARTING (fIG. 20–23)
WARNING: To reduce the risk
of injury, read the pressure washer
instruction manual and the engine
instruction manual before starting
pressure washer.
tank
DANGER: Risk of fluid injection
and laceration. When using the high-
pressure setting, DO NOT allow
the high-pressure spray to come in
contact with unprotected skin, eyes,
or with any pets or animals. Serious
injury will occur.
• Your washer operates at fluid
pressures and velocities high
f
enough to penetrate human and
animal flesh, which could result
in amputation or other serious
injury. Leaks caused by loose
fittings or worn or damaged
hoses can result in injection
injuries. DO NOT TREAT FLUID
INJECTION AS A SIMPLE CUT!
See a physician immediately!
14- ENG