Troubleshooting Guide - Black and Decker BDX2700 Manual De Instrucciones

All manuals and user guides at all-guides.com
OPERATIONAL POSSIBLE CAUSE
ISSUE
Engine will No fuel
not start (see
Pressure builds up after
Engine Owners
two pulls on the recoil
Manual for
starter or after initial use
further engine
Choke lever in the "No
troubleshooting)
Choke" position
Spark plug wire not attached. Attach spark plug wire.
Engine switch in OFF
po si tion
Choke lever in the "Choke"
position on a "hot" engine
or an engine that has been
exposed to thermal heat
for a long period of time
No or low Spray wand not in
pressure high pressure
(initial use)
Low water supply
Leak at high pressure
hose fitting
Nozzle obstructed
Water filter screen clogged
Air in hose
Choke in the "Choke" position Move choke to the "No Choke"
High pressure hose
is too long
TrOUbLE SHOOTING GUIDE
20- ENG
SOLUTION
Add fresh fuel
Squeeze gun trigger to relieve
pres sure
Move choke to the "Choke"
po si tion
Place engine switch
in ON position
Move choke to the "No Choke"
po si tion
See how to Use Spray
Wand instructions in the
Operation Section
Water supply must be at
least 5 gpm @ 20 psi
Repair leak. Apply sealant tape
if necessary
See Nozzle Cleaning
instructions in the
Maintenance section
Remove and clean filter.
Turn off the engine, then the
water source. Disconnect the
water source from the pump
inlet and turn the water source
on to remove all air from the
hose. When there is a steady
stream of water present, turn
water source off. Re- con nect
water source to pump inlet and
turn on wa ter source. Squeeze
trigger to re move re main ing air
po si tion
Use high pressure hose under
100 feet (30 m)