Black and Decker BDX2700 Manual De Instrucciones página 15

All manuals and user guides at all-guides.com
DANGER: Carbon Monoxide.
Using an engine indoors can kill you
in minutes. Engine exhaust contains
high levels of carbon monoxide (CO),
a poisonous gas you cannot see or
smell. You may be breathing CO even
if you do not smell engine exhaust.
• Breathing ex haust fumes will
cause se ri ous injury or death!
En gine exhaust contains carbon
mon ox ide, an odorless and
deadly gas.
• Operate pressure washer in a
well-ventilated
en closed areas such as ga rages,
base ments, etc.
• Never op er ate unit in or near a
lo ca tion occupied by humans or
animals.
WARNING: Risk
Asphyxiation and Burn. Never fill fuel
tank when engine is running or hot.
Do not smoke when filling fuel tank.
• Never fill fuel tank completely.
Fill tank to 1/2" (12.7 mm) below
bottom of filler neck to provide
space for fuel expansion. Wipe
any fuel spillage from engine
and equipment before starting
engine.
• DO NOT let hoses come in
contact with very hot engine
muffler during or immediately
after use of your pressure washer.
Damage to hoses from contact
with hot engine surfaces will NOT
be covered by warranty.
NOTICE: Risk of property damage.
Never pull water supply hose to move
pres sure washer. This could damage
hose and/or pump inlet.
• DO NOT use hot water, use cold
water only.
• Never turn water supply off
while pressure washer engine is
running or damage to pump will
result.
• DO NOT stop spraying water for
more than two minutes at a time.
Pump operates in bypass mode
when spray gun trigger is not
pressed. If pump is left in bypass
mode for more than two minutes
internal components of the pump
can be damaged.
If you do not understand these
precautions,
customer
www.power-washer.us
Prior to starting, refer to your engine
owners manual for proper starting
procedure.
area. Avoid 1. In a well ventilated outdoor area
add fresh, high quality, unleaded
gasoline with a pump octane rating
of 86 or higher. Do not overfill. Wipe
up spilled fuel before starting the
engine. Refer to Engine Owners
Manual for correct procedure.
of fire,
Check engine oil level. See Engine
2.
Owners
procedure.
3. Connect the water hose to the
water source. Turn the water
source on to remove all air from
the hose. When a steady stream
of water is present, turn the water
source off.
4. Verify the filter screen (M) is in
water inlet of pump. NOTE: Cone
side faces out.
5. Connect water source (N) to pump
inlet (J). NOTE: Water source must
provide a minimum of 5 gallons per
minute at 20 psi.
21
15 - ENG
please contact
service department
Manual
for correct
20
M
J
N
our
at