Checking The Battery Condition; Maintenance And Care - Waeco MOBITRONIC PS-300-IC Instrucciones De Uso

The charge status is indicated only properly 15 minutes at the earliest after the charging
process has been finished and the charging cord/mains charger has been pulled out or a
consuming unit has beendisconnected.
- Push the button "Test Battery" (see ✎ C 2).
Depending on the charging level of the battery, up to 4 LEDs light up (see ✎ C 3):
High = the battery is charged. No charging required.
Mid = the battery is sufficiently charged for actual operation but needs charging after use.
Low = the battery is nearly empty and should be charged.
Empty = the battery is empty. Charge the battery.
The PowerCombi is equipped with an undervoltage protection. With low discharging, the
PowerCombi switches off automatically. Please charge the PowerStarter immediately to
avoid damage.
The PowerCombi is equipped with a maintenance-free 12 V, 18 Ah battery.
Caution! Avoid strong heating-up of the PowerCombi, e. g. strong solar
radiation in the vehicle, heating up by the vehicle heating system etc.
With too strong heating up there is the danger of explosion!
Charge the PowerStarter every 3 months when not in use. To clean the PowerCombi, use
a soft dry cloth. To remove stubborn dirt, use a cloth which is only slightly dampened with
water. Do not use solvents.

Checking the battery condition

Maintenance and care

24