Liquid Vacuuming Operation - Kenmore KW3050 Manual De Uso Y Cuidado

WARNING
Be sure to read, understand, and apply
information entitled 'important safety
instructions'. Do not vacuum in areas
with flammable gases, vapors, or
explosive dusts in the air. Flammable
gases or vapors include but are not
limited to: lighter fluid, solvent type
cleaners, oil-based paints, gasoline,
alcohol, or aerosol sprays. Explosive
dusts include but are not limited to:
coal, magnesium, grain, or gun powder.
To reduce the risk of health hazards
from vapors or dust, do not vacuum
toxic materials.
WARNING
Do not plug the power cord into
electrical supply. Make sure the plug
is disconnected before changing the
filters.
1. Verify that the power cord is
disconnected from the outlet. Make sure
that the collection tank is clean and free
of dust and dirt.
2. Remove the cartridge filter, then
carefully install the foam wet filter over
the filter cage and place the power
head back on the collection tank. For
foam wet filter installation instructions,
see page 19.

LIQUID VACUUMING OPERATION

CAUTION
DO NOT USE THE CARTRIDGE FILTER
FOR LIQUID VACUUMING.
3. Choose the desired accessories and/
or the telescoping wand, then insert
onto the end of the hose. The air flow
regulation allows you to manually
change the amount of vacuum suction.
When the two triangles are aligned,
suction will be weakest.
4. Verify that the on/off switch is in the 'O'
OFF position before plugging the power
cord into the power outlet. Plug the
power cord into the outlet.
- 15 -