Kenmore KW3050 Manual De Uso Y Cuidado página 11

6. Insert the handle into the slots located
on the top of the power head and secure
it with the screws provided. Do not over-
tighten the screws.
7. Position the hose storage rack as
illustrated. Insert one side of the rack
into the channel making sure it is secured
in place. Squeeze in the other end and
insert it into the corresponding channel
making sure it is secured.
8. Your vacuum comes ready for dry
vacuum cleaning. If the cartridge filter
is not installed, refer to page 18 for
installation instructions.
9. For wet vacuum cleaning, remove the
cartridge filter, and install the supplied
foam wet filter. See page 19 for the
foam wet filter installation instructions.
ASSEMBLY INSTRUCTIONS
- 11 -
10. Place the power head back on the
collection tank aligning the top section
with the latches, and snap into place.
11. Hang the tool caddy onto the hooks on
the back of the vacuum.
12. Insert the large end of the hose onto
the vacuum port on the collection tank
and secure by turning clockwise until
tight.