Avidsen 100731 Manual De Instrucciones página 30

Tabla de contenido

Idiomas disponibles

A-Home: the sensor will not trigger the alarm if the central unit is in Home mode

. This mode

can be paired for example with PIR sensors inside the house, so that when you activate the Home

mode

s, you can enter your home without triggering the alarm, providing both perimeter and

outside protection thanks to the presence of the door/window sensors that remain active because

they are not paired with this mode.

B-Delayed: You can set sensors delays in relation to alarm system triggering. Recommended

function for example for door/window contacts.

C-Normal: the sensor will trigger will trigger the alarm when the central unit is armed

or in

Home mode

D-24h: Regardless of whether the system is armed or disarmed, the paired sensors will remain

24hrs active. Useful with smoke detection sensors.

For this association, act directly on the jumpers located inside (6 for the magnetic contact, 7

for the PIR).

Total resent

Press the Switch button and the SOS button at the same time. Release them after an acoustic

confirmation (3 beeps). Wait for 10 seconds. The central unit emits 2 beeps: The system has

been reset to factory values. All telephone numbers stored and the accessories will be deleted

Tabla de Contenido

Tabla de contenido