Wireless Remote Control - Avidsen 100731 Manual De Instrucciones

Wireless remote control

Use the remote control to arm/disarm the central unit and set the SOS emergency status.
PIR Wireless Sensor
The motion detector uses fuzzy logic for an intelligent analysis of surveillance areas. This tech-
nology detects interference generated by the moving body thus reducing false alarms rate. With
automatic temperature compensation technology, it easily adapts to environmental changes.
Has a detection range of up to 8m and a detection angle of up to 110.
Top view
ARM: Press the Arm button to arm the alarm. The central unit will beep to
acknowledge the receipt of the command.
DISARM: Press Disarm to disarm the alarm system. The central unit will
beep twice to the acknowledge receipt of the command.
HOME: Press the Home button to arm the alarm system in Home mode.
The central unit will beep twice to acknowledge the receipt of the command.
SOS: The SOS button starts the emergency scenario and at the same time, the
central unit will send an SMS notification (e.g. "RC-01 SOS", where 01 is the
remote control number) to all the preset phone numbers and will start to call.
Detection range
110°
0mt 2mt
2mt
0mt
Side view
4mt 6mt 8mt
GB
11