Before You Start; If Removing An Existing Toilet; Back-To-Back Installation - American Standard Edgemere 204AA Serie Instrucciones De Instalación Cuidado Y Mantenimiento

Before You Start:

Turn Off Water Supply
Recommended fitting type for
back-to-back installations.
1
NOTE: 1/4" EZ-BOLTS INCLUDED.
IF 5/16" BOLTS ARE REQUIRED,
PURCHASE SEPARATELY.
3
Apply weight evenly.
Do not move after
placement. Water
tight seal may break.

If Removing An Existing Toilet

Flush to remove
water from tank;
sponge remaining
water from
bowl before
removing toilet.
Depending upon your plumbing and venting conditions, the flow from the toilet in a back-to-back
installation may create a vacuum on the system and draw water from the opposing bowl. The
National Standards Plumbing Code prohibits the use of a cross fitting for drainage as throw over
is possible. The code does approve a directional "Y" style fitting with proper venting to direct the
water downward and away from the other toilet.
- 2 -
Clean Flange
Caution: If leaving floor flange
!
open for more than 1-2 hours,
cover flange to prevent escaping
sewer gases.

BACK-TO-BACK INSTALLATION

2
Press firmly.
4
Hand tighten
!
only. Do not
overtighten.
Wax Ring
(sold separately)
7 3 0 2 4 0 6 - 10 0