Before You Start; If Removing An Existing Toilet; Back-To-Back Installation - American Standard Cadet 270AA Serie Instrucciones De Instalación Y Mantenimiento

ROUGHING-IN DIMENSIONS:
NOTE: Distance from wall to closet flange centerline must be as listed on chart under ROUGH-IN DIMENSION "A", the BOWL HEIGHT is listed as DIMENSION "B".
FINISHED WALL
A

Before You Start:

Turn Off Water Supply
Recommended fitting type for
back-to-back installations.
1
SUPPLY
AS
REQ'D.
FINISHED
FLOOR

If Removing An Existing Toilet

Flush to remove
water from tank;
sponge remaining
water from
bowl before
removing toilet.
Depending upon your plumbing and venting conditions, the flow from the Cadet
back-to-back installation may create a vacuum on the system and draw water from the opposing
bowl. The National Standards Plumbing Code prohibits the use of a cross fitting for drainage as
throw over is possible. The code does approve a directional "Y" style fitting with proper venting to
direct the water downward and away from the other toilet.
ROUGH-IN
BOWL SHAPE
RIGHT HEIGHT 12" (305mm) 16-1/2" (419mm) 270AA
®
ELONGATED 10" (254mm) 16-1/2" (419mm) 270AB
RIGHT HEIGHT 12" (305mm) 16-1/2" (419mm) 270BA
®
ROUND FRONT 10" (254mm) 16-1/2" (419mm) 270BB
COMPACT RIGHT 12" (305mm) 16-1/2" (419mm) 270FA
HEIGHT ELONGATED 14" (356mm) 16-1/2" (419mm) 270FC
®
ELONGATED 12" (305mm) 15" (381mm)
10" (254mm) 15" (381mm)
ROUND FRONT 12" (305mm) 15" (381mm)
10" (254mm) 15" (381mm)
Clean Flange

BACK-TO-BACK INSTALLATION

2
Press firmly.
- 2 -
BOWL HEIGHT COMBO
DIM. "A" DIM. "B" MODEL
270CA
270CB
270DA 3717D 4021
270DB 3717D 4019
Caution: If leaving floor flange
!
open for more than 1-2 hours,
cover flange to prevent escaping
sewer gases.
Wax Ring
(sold separately)
73 019 6 7- 10 0 Rev. C
BOWL TANK
MODEL MODEL
3717A 4021
3717A 4019
3717B 4021
3717B 4019
3717F 4021
3717F 4019
3717C 4021
3717C 4019
® PRO in a