Before You Start; Back-To-Back Installation - American Standard Cadet PRO Serie Manual De Uso

ROUGHING-IN DIMENSIONS:
NOTE: Distance from wall to closet flange centerline must be as listed on chart under ROUGH-IN DIMENSION "A", the BOWL HEIGHT is listed as DIMENSION "B".
FINISHED WALL
A

Before You Start:

Turn Off Water Supply
Recommended fitting type for
back-to-back installations.
1
NOTE: 1/4" EZ-BOLTS INCLUDED.
IF 5/16" BOLTS ARE REQUIRED,
PURCHASE SEPARATELY.
SUPPLY
AS
REQ'D.
B
FINISHED
FLOOR
If Removing An Existing Toilet
Flush to remove
water from tank;
sponge remaining
water from
bowl before
removing toilet.
Depending upon your plumbing and venting conditions, the flow from the Cadet
back-to-back installation may create a vacuum on the system and draw water from the opposing
bowl. The National Standards Plumbing Code prohibits the use of a cross fitting for drainage as
throw over is possible. The code does approve a directional "Y" style fitting with proper venting to
direct the water downward and away from the other toilet.
BOWL SHAPE
RIGHT HEIGHT ®
ELONGATED
RIGHT HEIGHT
®
ROUND FRONT
COMPACT RIGHT
HEIGHT ELONGATED 14" (356mm) 16-1/2" (419mm) 215FC
®
B
ELONGATED
ROUND FRONT

BACK-TO-BACK INSTALLATION

2
Press firmly.
- 2 -
ROUGH-IN BOWL HEIGHT COMBO
DIM. "A" DIM. "B" MODEL
12" (305mm) 16-1/2" (419mm) 215AA
10" (254mm) 16-1/2" (419mm) 215AB
12" (305mm) 16-1/2" (419mm) 215BA
10" (254mm) 16-1/2" (419mm) 215BB
12" (305mm) 16-1/2" (419mm) 215FA
12" (305mm) 15" (381mm) 215CA
10" (254mm) 15" (381mm) 215CB
12" (305mm) 15" (381mm) 215DA 3517D 4188A
10" (254mm) 15" (381mm) 215DB 3517D 4188B
Clean Flange
Caution: If leaving floor flange
!
open for more than 1-2 hours,
cover flange to prevent escaping
sewer gases.
Wax Ring
(sold separately)
BOWL TANK
MODEL MODEL
3517A 4188A
3517A 4188B
3517B 4188A
3517B 4188B
3517F 4188B
3517F 4188A
3517C 4188A
3517C 4188B
®
PRO in a
7 3 018 7 8 - 10 0 Rev. B