Before You Start; If Removing An Existing Toilet; Back-To-Back Installation - American Standard TOWN SQUARE S 4216.228 Instrucciones De Instalación Cuidado Y Mantenimiento

Before You Start:

Turn Off Water Supply
Recommended fitting type for
back-to-back installations.
1
4
Apply weight evenly. Do not move after
placement. Water tight seal may break.

If Removing An Existing Toilet

Flush to remove
water from tank;
sponge remaining
water from
bowl before
removing toilet.

BACK-TO-BACK INSTALLATION

Depending upon your plumbing and venting conditions, the flow from the toilet in a back-to-back
installation may create a vacuum on the system and draw water from the opposing bowl. The
National Standards Plumbing Code prohibits the use of a cross fitting for drainage as throw over
is possible. The code does approve a directional "Y" style fitting with proper venting to direct the
water downward and away from the other toilet.
2
Press firmly.
5
Hand Tighten Only.
!
Do Not Overtighten.
- 2 -
Clean Flange
Caution: If leaving floor flange
!
open for more than 1-2 hours,
cover flange to prevent escaping
sewer gases.
3
Wax Ring
TIP: Place 2 pieces of masking
tape on floor (as shown) to help
with alignment in step 4.
6
Tank-to-Bowl Gasket
Place the tank gasket over the tank nut
ensuring there are not gaps between the
gasket and the chinaware.
7 3 02 3 54 - 10 0 Rev. A 4 / 18