Intended Use - Hilti NURON BX 3-22 Manual De Instrucciones

Status
One (1) LED slow-flashes green
One (1) LED quick-flashes green
One (1) LED quick-flashes yellow
One (1) LED shows yellow
One (1) LED quick-flashes red
3.6.2 Indicators showing the battery's state of health
To check the battery's state of health, press the release button and hold it down for longer than three
seconds. The system does not detect a potential malfunction of the battery due to misuse, for example
battery dropped or pierced, external heat damage, etc.
Status
All LEDs show in sequence, followed by one (1)
LED showing constantly green.
All LEDs show in sequence, followed by one (1)
LED quick-flashing yellow.
All LEDs show in sequence, followed by one (1)
LED showing constantly red.
3.7 Bluetooth (optional)
®
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use
®
of such marks by Hilti Corporation is under license.
3.7.1

Intended use

This product is equipped with a Bluetooth
power tool and the transfer of settings and data based on Bluetooth
system by which the two Bluetooth-enabled products can communicate with each other over a short
distance. This product is designed to enable communication and data transfers between smart phones and
Hilti gateway. The product can submit data attributes such as location of the receiving device, runtime,
total application count, application count during interval and timestamp of transfer. Information about the
connectivity functions offered can be found in the respective Hilti application (app) or in the operating
instructions of the power tool you are using.
3.7.2 Data transmission via Bluetooth
The transmission interval can vary, depending on the available power source of the product. The signal range
may vary greatly depending on external conditions, including the receiving device used. The Bluetooth
range may be significantly weaker inside closed rooms and through metallic barriers (e g. walls, shelving
units, cases, etc.). Depending on ambient conditions, several transmission intervals may be required before
the tool is detected.
If the tool is not detected, check the following:
• Is the distance to the mobile terminal device too great?
→ Reduce the distance between the mobile terminal device and the tool
26 English
Meaning
State of charge: < 10 %
The Li-ion battery is completely discharged.
Recharge the battery.
If the LED again starts quick-flashing after the bat-
tery has been charged, consult Hilti Service.
The Li-ion battery or the product in which it is in-
serted is overloaded, too hot or too cold, or experi-
encing some other fault.
Bring the product and the battery to the recom-
mended working temperature and do not overload
the product when it is in use.
If the message persists, consult Hilti Service.
The Li-ion battery and the product in which it is
inserted are not compatible. Consult Hilti Service.
The Li-ion battery is locked and cannot be used.
Consult Hilti Service.
Meaning
The battery can remain in use.
The check to ascertain the battery's state of health
did not complete. Repeat the procedure, or consult
Hilti Service.
If a connected product can still be used, the re-
maining battery capacity is below 50 %.
If a connected product can no longer be used, the
battery has reached the end of its useful life and
has to be replaced. Consult Hilti Service.
Low Energy Module which enables the status checking of a
®
®
2268212
wireless technology, a data transfer
®
*2268212*
®