Transport; Storage; Care And Service - Kärcher CVS 65/1 Bp Pack Manual Del Usuario

Sweeping with a roller brush and side brush
On/Off switch
1
Adjusting the contact pressure of the roller brush (twist grip)
2
Roller brush contact pressure display
3
– LED does not light up: Lower the roller brush further
– Green LED: correct adjustment
– Red LED: Raise the roller brush
Lower side brush
4
Side brush adjustment
5
– Adjust contact pressure
– Raise side brush
1. Switch on the device with the On/Off switch (position I).
a Roller brush and side brush rotate.
2. Push the device forward on the push handle and start clean-
ing. Use the roller brush contact pressure adjustment in accor-
dance with the textile pile.
a To adjust, lift the twist grip, then turn.
b The correct contact pressure is indicated by a green LED.
3. For cleaning close to the edge, lower the side brush by press-
ing the side brush lowering button.
a If necessary, use the side brush adjustment and set the con-
tact pressure.
4. To pick up larger objects (20 mm), push the push handle down
a little so the roller brush can move the objects into the waste
container.
5. An automatic cleaning of the pre-filter ensures continuous
work.
6. Always recharge the battery in good time.
a During the sweeping operation, the display in the battery
shows the remaining time in minutes.
b When the device is switched off, the battery charge is dis-
played in %.
Stop and turn off the device
1. To finish the work, switch off the device with the On/Off switch
(position 0).
2. Park the device on a level surface.
3. Lift the twist grip of the roller brush and turn it counterclockwise
all the way up.
4. Pull the lowered side brush up using the adjustment. The side
brush locks into place.
5. Empty the waste container.
6. Clean the dust filter and pre-filter.
7. Charge the battery.
Emptying the waste container
Waste container lock
1
Waste container
2
1. Operate the lock of the waste container (pull it backwards).
2. Tilt the waste container backwards and pull it out.
3. Empty the waste container or remove the dust bag (option).
4. Insert the waste container and push it all the way to the front.
If necessary, insert the dust bag (option) beforehand as de-
scribed in the Chapter "Dust bag (option)".
5. Check whether the waste container is engaged.
CAUTION
Risk of injury and damage
Be aware of the weight of the device during transportation.
1. Switch off the device with the "ON/OFF switch".
2. Lift the twist grip of the roller brush and turn it counterclockwise
all the way up.
3. Secure the device to the wheels with wedges.
4. Secure the device with ropes or tension straps.
a At the front of the frame under the cover.
b At the rear in the push handle attachment area.
5. Secure the device in accordance with the respectively applica-
ble guidelines to prevent it from slipping or overturning when
in transport.
WARNING
Risk of injury and damage
Be aware of the weight of the device.
1. Park the device in a sheltered, level and dry place.
2. Remove the battery.
a Observe the notes in the operating instructions for storing
the battery.
3. Clean the inside and outside of the device.
4. Lift the twist grip of the roller brush and turn it counterclockwise
all the way up.
DANGER
Risk of accident and injury from unintentional movement of
the device
Switch off the device and unplug the battery before starting any
care or maintenance work.
CAUTION
Short circuit hazard from water stream
Do not clean the device with a hose or high pressure water jet.
English

Transport

Storage

Care and service

General notes
Cleaning the device
7