Manual Time Setting; Alarm Setting - Techno Line WT 199 Manual De Instrucciones

- LCD
- Backlight
KEY STATEMENT
::
Time Alarm
Setting Up
:
1. Firstly, open the battery cover at the back of the clock.
2. Checking the correct polarization, insert 2 x AAA, LR03, 1.5V batteries into the compartment and replace the cover.
3. When the batteries are inserted, the clock will be automatically scanning for the radio controlled time signal.
4. If after 6 minutes the DCF time has not been received, you can manually set the time. (see chapter manual time
setting)
5. If the clock cannot receive the signal at the first time, it will automatically attempt to receive the signal again one
hour later.
6. Die The clock will automatically receive the signal everyday 2.00 AM.
7. When the clock is scanning for signal, only the WAVE key is operational

MANUAL TIME SETTING:

In some cases after inserting the batteries, the clock may not be able to receive the DCF signal. In this situation, the
time should be set manually.
1. Press and hold the TIME SET key for 3 seconds and the "hour" digits will start flashing, press
adjust the hour.
2. Press the TIME SET key again and the "minute" digits will start flashing, press the
minute.
3. Press the TIME SET key again and the "second" digits will start flashing, press the
"second" to 0.
4. Press the TIME SET key again and the "year" digits will start flashing, press
5. Press the TIME SET key again and the "dash" between "date" and "month" will start flashing, press
to shift the position of "date" and "month".
6. Press the TIME SET key again and the "month" digits will start flashing, press the
month.
7. Press the TIME SET key again and the "date" digits will start flashing, press the
8. Press the TIME SET key again and then press the
9. Press the TIME SET key again and then press the die
week.
It can be adjusted the following languages: GER; ENG; FRA; ITA; SPA
10. Press the TIME SET key again to return to normal display.

ALARM SETTING:

1. Press the ALARM Set key.
2. Press and hold the ALARM SET key for 3 seconds and the "minute" digits of alarm time will start flashing, press
or, key to adjust the minute.
3. Press the ALARM SET key again and the "hour" digits of alarm time will start flashing, press
12/24 °C/°F / Wave Alarm On/Off
or key to set the time zone.
or key to choose the language for the Day of
or
or key to adjust the
or key to clear the
or key to adjust the year.
or
or key to adjust the
or key to adjust the date.
or
key to
key
key to