Temperature Alarm Setting - Techno Line WS 7060 Manual De Instrucciones

values. Outdoor sensors can be placed away from the main station as soon as all channels are receiving
values.
Note:
Should the sensor reception fail after 3 minutes, the reception symbol
In this case, restart initial operation with a set of fresh and full batteries until all sensors can be connected.

Temperature alarm setting

- In normal display mode, press the Alert button for 3 seconds to enter alert setting mode
In alert setting mode, press the + or – button to select an outdoor channel.
-
- Press the Alert button to confirm the selected channel. The down limit symbol
Press the + or – button to change the value of the down limit.
-
- Press the Alert button to confirm the alert changes. The up limit symbol
Press the + or – button to change the value of the up limit.
-
- Press the Alert button to confirm the alert changes. The up&down limit symbol
Press the + or – button to activate the alarm and the alarm symbol
-
again to deactivate the alarm and alarm symbol
- Press the Alert button to confirm the alert changes and exit the alert setting mode.
Note:
- The alarm symbol
activated.
Down limit default value is 0 ℃, up limit default value is 35℃.
-
- In alert setting mode, it will be exit when there is no any operation in 20 seconds
In alert setting mode, press the + or – button once to change value by 1 unit or hold the + or – button to quicker
-
adjust the value.
Temperature alarm
- This station has an up limit & down limit for 3 alarms, one for each outdoor channel.
- If temperature reaches a limit, is higher then up limit or below down limit, then the
symbols will flash and the alarm will sound.
- While alarming, press any button to stop the alarm sound, but the
sound will also turn off automatically after 1 minute, if no button is pressed.
- The symbol will no longer blink and become permanent again, once the temperature value is no longer at
or beyond the set temperature limit.
Note
- The alarm can permanently be deactivated by using the temperature alearm setting.
Manual – WS 7060
will be permanently displayed in the corresponding channel as long as the alarm stays
- EN03 -
of the specific channel will disappear.
is blinking. Press the + or – button
is no longer displayed.
symbol will still be flashing. The alarm
is blinking.
is blinking.
is blinking.
or and the