Permobil ROHO AGILITY Back Support Fixed Hardware Manual Del Operador página 8

AGILITY Installation, continued
Place the AGILITY On the Wheelchair - Option A or Option B
Installation Option A
2. Push against the bolt with your thumb, and pry the pivoting band
away from the adjustment cylinder. Rotate the pivoting band.
Repeat for the other side.
3. Place the pivoting bands
around the wheelchair canes:
With your thumb against the
bolt, attach the pivoting band
so the narrow part of the
opening is on the groove in
the adjustment cylinder.
Tighten the Bolts - Option A and Option B
IMPORTANT! Make sure the mounting hardware is flush
against the wheelchair canes.
4. For both sides: Finger-tighten the bolt.
Note: As you tighten each bolt, pinch or squeeze the pivoting band
to help the narrow part of the opening engage with the groove in
the adjustment cylinder.
5. If you are not able to attach the hardware or tighten the bolts,
you may need to adjust the width:
Loosen, but do not remove, the width/height adjustment nuts.
- Slide the triangle brackets
forward for a wider width.
- Slide the triangle brackets
backward for a narrower
width.
ROHO AGILITY Fixed Hardware Operation Manual
Pivoting
Band
Adjustment
Cylinder
wider
narrower
Installation Option B
2. The pivoting bands should
remain attached to the
adjustment cylinders.
3. Slide the pivoting bands onto
the wheelchair canes.
IMPORTANT! Use the reference grooves to make sure the left and
right triangle brackets are in the same position on both sides.
6
Pivoting
Band
Adjustment
Cylinder
Reference Grooves