Flip The Back Shell - Permobil ROHO AGILITY Back Support Fixed Hardware Manual Del Operador

Seat Depth and Angle Adjustment, continued
To Adjust the Angle
1. If not yet loosened,
use the Allen wrench
to loosen the depth/
angle adjustment
bolts approximately
two (2) full rotations.
2x
2. Pivot the back shell.
IMPORTANT! After installation and adjustment is complete, tighten hardware securely before transferring into the wheelchair. Refer to the
appropriate sections in this manual for recommended torque specifications. If the individual is seated in the wheelchair, and depth and angle
re-adjustments are needed, review "Warnings" at the beginning of this section and re-adjust as necessary. Re-tighten all hardware securely.

Flip the Back Shell

1. Remove the AGILITY from the wheelchair. See "AGILITY Removal".
2. Remove the back shell hardware on both sides:
- Use the box end wrench to remove the width/height adjustment nuts.
- Remove the triangle brackets from the back shell.
ROHO AGILITY Fixed Hardware Operation Manual
IMPORTANT! Compare the markers on
the front of the fixed hardware to make sure
both sides are rotated the same.
Note: 5 degree increments per mark (15
degrees of anterior and posterior tilt)
3. Rotate the back shell.
4. Install and adjust the AGILITY. See all adjustment and installation
Note: When installing the flipped back shell, make sure the AGILITY
Cover is also in the flipped position.
Triangle
Bracket
10
3. While you hold the back shell in position,
use the Allen wrench to tighten the right
and left depth/angle adjustment bolts,
turning until snug + one-quarter turn.
Note: If a torque wrench is available,
tighten the bolts to 60 ± 4 inch-pounds (7
± 0.5 Newton-meters).
instructions provided with the product.