2.2 USING THE CONTROL PANEL
•
The arrow buttons
•
When selecting a given function, any submenus available can be scrolled using the
parameter simply use the
button confirms the setting.
•
In general all values that are flashing can be modified using the
•
The "annulla" button
active alarm or error codes.
2.3 OPERATING PARAMETERS
Stove operation is determined by the Power level and Temperature parameters set by the user.
2.3.1 setting the power level
The power level defines the amount of heat produced by the stove and consequently directly affects fuel consumption.
To change the power level use the
a) Use the
buttons to scroll the submenu
b) Select submenu "1" and confirm by pressing
c) The power level value will flash; set the value using the
d) Press
to confirm the settings.
2.3.2 Setting the temperature
Different temperature values can be set depending on the boiler's configuration:
a) Use the
buttons to go to the temperature menu
b) The current value will flash; change it using the
c) Press
to confirm the settings.
Water temperature (configurations 1 only): setting this value changes the desired hot water outlet temperature.
Room temperature (configuration 2 only): setting this value defines the desired room temperature, read directly by
a probe fitted on the boiler.
Storage temperature (configurations 3 and 4 only): identifies the minimum desired temperature inside the storage tank.
20
are used to scroll between the different menus that are highlighted.
button and modify the values, again using the
goes back up one level in the menu; pressing and holding the button displays any
buttons to go to the power menu
.
buttons
buttons.
(buttons (1 minimum,....5 maximum)
and press
;
buttons; to set a
buttons. Pressing the
004778911 - 26/01/2022