Restart Delta Function; Manual Activation Of The Load System - Palazzetti DISPLAY EASY Uso Y Funciones

5.6 RESTART DELTA FUNCTION

Restart delta (configurations 2, 3 and 4) is the number of degrees centigrade below the switch-off temperature at which
the stove switches on again automatically. For example, if the stove is set to switch off at 20°C (Eco Mode active) and
"Restart delta" is set to 4°C, the stove will switch on again when the temperature measured is less than or equal to 16°C.
CONFIGURATION 2:
To set the restart delta value:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Select submenu and press
[8]
d) The value will flash; change it using the
e) Press the button to confirm the set value.
CONFIGURATION 3 AND 4:
To set the restart delta value:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Select submenu and press
[8]
d) The value will flash; change it using the
e) Press the button to confirm the set value.

5.7 MANUAL ACTIVATION OF THE LOAD SYSTEM

In case of first use (pellet tank initially empty) or to test operation of the load unit, manual activation of loading is possible.
On the control panel of the stove:
a) Using the arrow keys
b) Select password "7" with the key
c) Scroll with the key
d) Select password "54" with the key
e) Holding the key the load system will activate and the display will show the incremental bars
f) Releasing the key will end the load operation.
Attention!
• This function is only active when the stove is off and cold.
• Before switching on again, ensure that there are no pellets in the grate.
004778911 - 26/01/2022
ITALIANO
to go to the setup menu
to confirm;
and
to go to the setup menu
to confirm;
and
navigate to the set-up menu
and confirm with the key
[3 1 ]
and select sub-menu
and confirm with the key
ENGLISH DEUTSCH
and then press
to confirm;;
buttons ( °C);
0,5 ... 5,0
and then press
to confirm;;
buttons ( °C);
0 ... 40
and press the key
;
;
;
FRANÇAIS ESPAÑOL
;
;
;
27