DeWalt DW077 Manual De Instrucciones página 12

All manuals and user guides at all-guides.com
Installing and Removing the
Battery Pack
NOTE: Make sure your battery pack is fully
charged before you install it.
INSTALLING THE BATTERY PACK
1. Rotate the battery adapter plate (A) so that the
applicable cut out for 9.6, 12, 14.4 volt pack or
the 18 volt pack is aligned with the battery
contacts facing the inside of the cut out.
2. Slide the battery pack in firmly until you hear the battery pack
lock in place.
REMOVING THE BATTERY PACK
1. Push the battery in slightly, press the release buttons, and firmly
pull the battery pack out of the receptacle.
2. The battery ejector pin (D) will aid in removing the pack.
3. To recharge the battery pack, insert it into the charger as
described in the charger section of this manual.
J K L
E
G F
Control Panel
A
The laser is controled by the power button (E), the speed/rotation
button (F), the scan mode button (G), and two arrows (H and I). The
arrows control the movement of the laser head left and right or up
and down depending on whether the laser is being used in the
D
level mode or the plumb mode. Three indicator lights are on the
control panel, power (J), X-axis leveling (K), and Y-axis leveling (L).
TURNING THE LASER ON
1. Insert the fully charged battery pack through the proper cut out in
battery adapter plate. Be sure that the battery is firmly engaged.
2. Gently press the ON/OFF button (E) to power the laser on. The
laser diode will turn on and the power LED Light (J) will illumi-
nate. If the laser is out of level, the X-axis and/or Y-axis leveling
lights (K and L) will flash until the laser is level. Press the
speed/rotation button (F) to make the head rotate.
NOTE: The head will only rotate momentarily if the laser is leveling.
The head will begin or resume rotation once the laser is level.
TURNING THE LASER OFF
Gently press the ON/OFF button to turn the laser off. The power
LED Light will no longer be illuminated.
ROTATION SPEEDS
The rotary head speed can be adjusted by pressing the speed/rota-
tion button. The head speed will cycle through 4 speeds and stop,
then repeat the sequence as the speed/rotation button is pressed.
REMEMBER:
Slow speed = Bright Beam
Using the Laser on a Tripod
1. Position the tripod securely and set it to the desired height.
I
2. Make sure that the top of the tripod is roughly level. the laser will
H
self-level only if the top of the tripod is within ± 5˚ of level. If the
8
Fast Speed = Solid Beam