Mafell MT55cc Instrucciones De Funcionamiento Y Seguridad página 25

MT55cc
In addition, some rails available on the market may also be used. To do this, remove the insert on the bottom
of the machine.
Use the following procedure to remove the
insert:
1. Loosen the screws (25) at the insert (26).
2. Pull out the insert (26).
The groove that appears now is used to
➢
set the machine on other guide rails.
Insert removed.
✓
5.10.2 Pre-scoring with the guide rail
To avoid tearing the surface of panel materials, use the pre-scoring function of the
machine when you work with guide rails. Here, the cutting depth is limited to 2.5 mm [0.1
in] and the saw blade is minimally offset from the cutting line.
Use the following procedure to use the pre-
scoring function of the machine:
1. Secure a guide rail on the workpiece.
2. Position the machine with the guiding groove
on the guide rail.
3. Rotate the notch for pre-scoring (3) clockwise
until it hits the stop.
The pre-scoring depth is now set to 2.5
➢
mm [0.1 in]
4. Pre-score the plate.
5. Rotate the notch for pre-scoring (3)
counterclockwise.
The workpiece can now be cut at the full
➢
cutting depth.
Pre-scoring function of the machine used
✓
01/2022
Fig. 25: Removing the insert for third-party rail
Fig. 26: Activating the pre-scoring function
Fig. 27: Deactivating the pre-scoring function
25