Greenlee 881 Manual De Instrucciones página 12

Assembly and Operation Instructions
881 and 881CT with 1813 Bending Table (cont'd)
11 and 12. Level the table at both ends.
Pump
Reservoir
13. Remove the rubber feet/casters from the pump.
Attach the pump bracket (64) to the pump with the
pump bracket mounting hardware (40–43). See
illustration.
Greenlee Tools, Inc.
881 and 881CT Hydraulic Benders
Pump
Bracket
12
14. Slide the pump onto the pump supports. Tighten
the screws on the lower sides of the pump brackets
to secure the pump. Verify that the pump supports
are 5" and 12" from the bender mounting unit.
Tighten the pipe clamp screws.
15 and 16. Load the connecting bar and roller unit into
the bender mounting unit.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070