Introduction; General Warnings - Iberspa SW11487 Manual De Uso E Instalación

ENG

1. INTRODUCTION

This manual contains all the information needed to fully enjoy your SPA. We recommend
that you take some time to go over the points detailed below.
If you have any question or doubt on the operation or maintenance of this product, please
will help you to enjoy this product.
without prior notice and without entering into any obligation.
This Spa has been designed and conceived for private use only: any public use shall
annul its guarantee.

2. GENERAL WARNINGS

Carefully follow current regulations regarding accident prevention and respect regulations
in each country.
Original spare parts and accessories authorised by the manufacturer guarantee greater
safety. The manufacturer of the equipment is exempt from all liability for damages caused
by using non-authorised spare parts or accessories.
• The manufacturer shall not be responsible for the damages caused by the assembly
of non-authorized accessories, nor for those caused by a improper handling by non-
if you have any doubts or need technical assistance.
• The equipment should be installed in a place which has been properly prepared and
where all components of the Spa can be easily accessed. The guarantee does not cover
work needed to be carried out to install or replace the product. (See the Guarantee).
and maintenance works, who have previously carefully read the installation and service
instructions.
• Contact the Technical Service of the manufacturer or your local dealer in the event of
malfunction or a breakdown.
• The installation of the Spa must at all times meet current regulations applicable in each
country, particularly those referring to electrical safety.
• This unit must be installed in an appropriately prepared area with easy access to all the
components of the Spa. The Guarantee does not cover any building work required to
position or replace the product. (See the Guarantee).
• During operation, some parts of the equipment are at dangerous electrical voltage
levels. Work on each element or equipment can only be performed once it has been
disconnected from the mains and with the start-up devices disconnected.
13