Light Maintenance; Maintenance In Periods Of Non-Use Or Absence - Iberspa SW11487 Manual De Uso E Instalación

• Remove dust, smears and dry dirt with a soft, moist cloth.
•
dry cloth.
• Avoid using razors or any other kind of sharp instrument that could scratch the surface.
polishing it with a clean cloth.
Once a week, clean the area of the Spa which is not underwater with a quality polish for
Spas.
ATTENTION
Remember to never leave the Spa uncovered and exposed to sunlight, as this
could cause damage not covered by the guarantee.

6.6. Light maintenance

Replacing the lamp is the only required maintenance on the spotlight. To replace the
lamp, follow these steps:
• Dismantle the wooden side panel where the spotlight is installed using a medium-sized
stecker screwdriver.
• To replace the lamp, turn the lamp-holder bushing anticlockwise and lift it from its
position.
• Once the faulty lamp has been replaced, place the lamp-holder back in position and
reassemble the wooden side panel of the Spa.
If you have any doubt about the explanation of this operation, contact your authorised
dealer or authorised technical service.
WARNING- RISK OF ELECTRIC SHOCK
The new lamp must have the same features as the lamp supplied.
Never install lamps without the front lens.
of the glass or replace it if you observe any dents or permanent damage.

6.7. Maintenance in periods of non-use or absence

SHORT PERIODS (3-5 days)
• Adjust the pH and treat the water (see Water Maintenance section).
• Cover the spa.
• Before using the Spa again, readjust the pH and treat the water again.
54