Iberspa SW11487 Manual De Uso E Instalación página 34

CONTROL SYSTEM FOR TP600
Fill the spa to its correct operating level. Be sure to open all valves and jets in the plumbing
After turning the power on at the main power panel, the top-side panel display will
PRIMING MODE - M019
This mode will last for 4-5 minutes or you can manually exit the priming mode after
the pump(s) have primed.
Regardless of whether the priming mode ends automatically or you manually exit the
at the end of the priming mode. During the priming mode, the heater is disabled to
allow the priming process to be completed without the possibility of energizing the
the pump(s) can be energized by pushing the "Jet" buttons.If the spa has a Circ Pump,
it can be activated by pressing the "Light" button during Priming Mode.
You can manually exit Priming Mode by pressing a "Temp" button (Up or Down). Note
that if you do not manually exit the priming mode as described above, the priming
mode will be automatically terminated after 4-5 minutes. Be sure that the pump(s)
have been primed by this time.
Once the system has exited Priming Mode, the top-side panel will momentarily
display the set temperature but the displaywill not show the temperature yet, as
shown below. This is because the system requires approximately 1 minute of water
ADJUSTING THE SET TEMPERATURE
When using a panel with Up and Down buttons (Temperature buttons), pressing Up
adjust the set temperature in the direction indicated on the button. When the LCD
temperature will continue to change until the button is released.
34
| TP600
| TP600