Problems And Solutions - Iberspa SW11487 Manual De Uso E Instalación

8. PROBLEMS AND SOLUTIONS

Problems
The massage pump of the Jets
does not work.
Spa does not work.
The massage pump of the air
Blower does not work.
Water leaks out through the Venturi. Jets are closed.
The water does not reach the
required temperature.
solve possible breakdowns.
Reasons
Filter is blocked by dirt.
The cable of the digital control
panel is disconnected from the
board.
No electrical supply.
The cable of the digital control
panel is disconnected from the
board.
No electrical supply
The pump has disconnected owing
to overheating.
Jets are not properly installed. The
outer trim of the jet turns a quarter
this trim makes a complete turn, it
is not properly installed, and the jet
will have to be removed and then
placed correctly.
Venturis are closed.
Starter brushes of the motor are
worn.
Probe is damaged.
Check programmed temperature.
Solutions
Connect the cable to the board.
Check that the pump is connected
to the electric control panel.
Connect the cable to the board.
Check that the pump is connected
to the electric control panel.
Let it cool for about 3 hours and
then start-up the pump again.
Open the jet.
Remove the jet. Pull the outer
trim about 2 cm. Unscrew the jet
turning anti-clockwise. Once it
has been dismantled, replace the
jet, by screwing in a clockwise
direction. Press the outer trim back
into place.
Open the Venturis.
Change the pump.
Replace the temperature probe.
Programme the temperature.
ENG
59