Electrical Connection - Iberspa SW11487 Manual De Uso E Instalación

ATTENTION
parts. If seawater is used in the Spa, the circuit components will quickly
deteriorate.
and damage equipment and connections.
following points:
• Adjust water ph between 7,2 and 7,6 (see 4.0 section).
• Add all required chemical products recommended in water maintenance (see 6.2 section)
• Select the required temperature (see Installation and assembly of the spa). remember
that if the water is cold, it may take 24 hours to reach a temperature of 38ºc.
• Before using the spa, check the ph values once again in case they have changed with
the treatments indicated above.

3.5. Electrical connection

ATTENTION
• This equipment cannot be connected to a normal plug.
• This equipment requires suitable electrical installation. This should be
each country.
• The electrical input of the Spa should always be protected by a highly
• Earthing connection is essential.
• Use a suitable section cable bearing in mind the power of the Spa and
distance to the control panel.
• Always follow instructions given in the Safety Warnings chapter of this
manual.
22