Iberspa SW11487 Manual De Uso E Instalación página 30

ATTENTION
It is very important to maintain the correct pH level both for the disinfectant to
work properly and to prevent corrosion or deposits on the Spa. Any damage
caused by an inadequate pH level is not covered by your Spa guarantee.
- The disinfectant will quickly dissipate.
- The equipment of the Spa become rusty.
- The water can start causing skin irritations to bathers.
- Scale may appear on the acrylic and equipment.
- The water may become cloudy.
Check the pH of the Spa water daily using the pH test set. (not supplied)
If the pH is above the indexes, use pH MINOR SPA. Wait for two hours and re-do the pH
test.
If the pH is below indexes, use pH MAJOR SPA. Wait for two hours and re-do the pH test.
When the pH index has been adjusted to the values indicated above, proceed to the next
step.
DISINFECTION OF THE WATER
Disinfection of the water is of utmost importance in order to destroy algae, bacteria and
organisms that could develop in the water. However, excessive disinfection could cause
skin and eye irritation.
BROMIDE TABLETS are a suitable disinfectant for the Spa water. This product is placed in
Check the residual bromide level daily using the Br analyser set.
The recommended level of residual bromide is between 2.2 and 3.3 ppm.
Do not forget to keep the water in good conditions (see 6.2 Water maintenance)
30