Mafell K55 18M bl Instrucciones De Funcionamiento Y Seguridad página 25

K55 18M bl / KSS50 18M bl
Use the following procedure to install the parallel
guide fence:
1. Loosen the wing screws (5) on both sides.
2. Insert the parallel guide fence (C) into the guide
provided for this purpose.
It can be mounted on the left or right side
➢
of the machine.
3. Tighten the wing screws (5) on both sides.
✓ The parallel guide fence is installed.
Use the following procedure to adjust the cutting
width:
1. Loosen the wing screws (5) on both sides.
2. Adjust the parallel guide fence.
3. Tighten the wing screws (5) on both sides.
The cutting width is adjusted.
✓
In addition, the parallel guide can also be used as a double support for a better guidance of
the hand-held circular saw. Simply turn it over (the guide tab (20) points upwards).
Alternatively, you can guide the machine with the parallel guide fence along a guide rail or a
wooden ledge fixed on the workpiece. This requires the parallel guide fence to be rotated so
that the guide tab (20) points upwards.
01/2022
Fig. 21: Installing the parallel guide fence
Fig. 22: Adjusting the cutting width via the parallel guide
fence
25