Riving Knife - Mafell K55 18M bl Instrucciones De Funcionamiento Y Seguridad

K55 18M bl / KSS50 18M bl
14. Close the movable guard.
15. To do this, press the locking lever (3) down.
The mechanism that locks the saw shaft is
➢
activated.
The operating lever is unlocked.
➢
The saw blade is changed.
✓

4.7 Riving knife

The riving knife prevents the saw blade from jamming during rip cutting. In addition, the riving knife retracts into
the machine during plunge cuts. This prevents kickback during the sawing process.
The correct distance to the saw blade is shown in the figure.
Use the following procedure to adjust the
distance of the riving knife:
1. Pull the rechargeable battery out of the
machine.
2. Using the Allen key (B) provided, turn the screw
(18) counterclockwise to adjust.
3. Move the riving knife along its longitudinal slot
to adjust it.
Do not exceed the maximum distance to
➢
the saw blade (see Fig.. 13).
4. Using the Allen key (B), turn the flange screw
(18) clockwise to tighten it.
The riving knife distance is set.
✓
01/2022
Fig. 12: Unlocking the operating lever
Fig. 13: Distance riving knife to saw blade
19