Zodiac NZO 600 Manual Del Propietário página 69

BUOYANCY CHAMBER – Installing the buoyancy chamber on the hull
INSTALLING THE BUOYANCY CHAMBER
The buoyancy chamber is delivered installed on the hull. Follow the instructions below when
replacing the buoyancy chamber.
NOTE:
1
To facilitate the positioning of the buoyancy chamber, apply liquid soap (a) to the hull rails
2
Position the buoyancy chamber's rope (a) on the hull's rail (b) situated at the forward end of
the hull. Pull the buoyancy chamber until the mini-boltrope is brought opposite the forward
rail (c).
The buoyancy chamber is fitted to the hull with the buoyancy
You can inflate the buoyancy chamber when not installed
(pressure 240 mb) and leave to stabilize for about an hour. Then
deflate it.
If the buoyancy chamber has been stored at a temperature lower
than 0°C, leave it for 12 hours at room temperature (20°C) before
folding it.
Page 15/ 52
chamber deflated.
a
c
b
E
N
G
L
I
S
H