Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Turn off your appliance
If the unit is not likely to operate for a long period of time:
▪ Remove all items from your appliance.
▪ Switch off the appliance by setting the thermostat to position "0".
▪ Unplug the appliance.
▪ Clean it thoroughly.
▪
Keep the door open to prevent odors from rising.
Changing the light bulb
This appliance consists of light-emitting diodes (LEDs). This type of diode cannot
be changed by the consumer. The lifetime of these LEDs is normally sufficient for
no change to be made. If however, and despite all the care taken during the
manufacture of your appliance, the LEDs were defective, please contact your after-
sales service for any intervention.
6. TROUBLESHOOTING GUIDE
Sometimes you may come cross minor problems that is most cases do not require
a service call and can be easily eliminated. Please refer to the below trouble-
shooting guide to assist you in identifying the problem still persist after completing
these checkpoints, contact the closest authorize service agent in your area for
assistance.
Problem
The appliance
doesn't produce
cold
The appliance is
not cold enough
Possible cause
1. Is there a problem with the
power supply?
2. Voltage is insufficient
3. Is the power word correctly
plugged?
4. Is the thermostat on the
0position?
1. Are there too many items inside
the appliance?
2. Is the thermostat set too low?
3. Is the appliance exposed to
direct sunlight or too close to a
heat source?
4. Are there warm items inside?
14
Solution
Check the main plug
Install an electric interface
Plug the cord correctly
Change the thermostat position
Remove some of the items
Set the thermostat at the correct
temperature.
Move the appliance away from
important heat sources.
Remove the warm items.
Publicidad
Tabla de contenido
