Infiniton FSB-618 Manual De Usuario página 29

are placing your equipment in an out-building such as a garage or annex ensure
that it is placed above the damp course, otherwise condensation will occur on the
appliance's cabinet. Never place the appliance in a wall recessed or into fitted
cabinets or furniture. When the appliance is ON, the metal grid at the back may
become hot and the sides warm. You must leave enough space on each side of
the appliance so the air can circulate.
Cleaning before use
Wipe the inside with a weak solution of bicarbonate of soda. Then rinse with
warm water using a damp sponge or cloth. Wash the baskets and shelves in
warm soapy water and dry completely before placing them back.
Handle installation:
The handle is made of three parts: handle, handle cover and two screws.
To install the handle, hold the handle on the door in alignment with the
holes, screw the handle to the door with the two screws provided, clip the
handle cover.
Before plugging in
Check that you have a socket which is compatible with the plug supplied
with the appliance.
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE APPLIANCE.
The coolant fluid needs time to settle. If the appliance is switched off at any time,
wait 30 minutes before switching back on to allow the coolant fluid to settle.
Before filling your appliance
Before storing beverage in your appliance, turn the appliance on and wait for 4
hours, to make sure it is working properly and to allow the appliance to reach the
correct temperature.
4. USE INSTRUCTIONS
Your appliance has one control for regulating the temperature. The temperature
control is located at the top of the appliance.
11