Alarms Display And Reset - Casals QUANTICA EEC Manual De Instalación, Operación Y Mantenimiento

18.5 Alarms display and reset

When there is an alarm which requires an immediate unit
STOP, the unit will turn off showing the "Unit OFF BY ALARM"
screen.
When an alarm appears it blinks the icon of the "RED BELL"
on the right side of the screen.
From the main screen, press the "ON / STAND-BY" key (sim-
ple pressure) to have access to the ALARM PAGE.
Pressing the "OK" key alarms will be displayed.
If there are no alarms, the "NO ALARM" screen is displayed.
If there are several active alarms, they can be displayed in
sequence by pressing the "UP" or "DOWN"keys.
To reset an alarm, is enough to press the "OK" key on it.
Once reset all the alarms, the blinking icon of the "RED BELL"
disappears and "NO ALARM" screen is displayed.
To go back to the main screen press the
ON / STAND-BY" key (simple pressure).
ATTENTION: automatic reset alarms reset themselves
once the cause of the alarm has been removed.
EN
PRESS
AND HOLD
49