Dexter 800ETC1 Manual De Instrucciones página 124

Regularly, depending on conditions of use
What
Check all screwed connections and tighten them
if necessary
Clean dust and splinters from the machine.
Remove all dust and splinters from the Ventilation
slits of the motor.
Remove deposits from the cold water pump.
Change the cooling water.
If necessary
What
Changing the cutting wheel.
Cooling water pipe is damaged.
If the cooling water pipe gets brittle, blocked or is damaged it can easily be replaced by another pipe of
the same type. Release the connections and the holders. Mount a new pipe with the same length. Fix it
(just like the old one).
LUBRICATING
From time to time the guiding rails and the bearings of the motor need to be lubricated.
them, together with the machine head to the same side as the transport wheels, then fasten the two
clamping screws again.
• Fold up the feet one after the other, ideally starting on the same side as the transport wheels so as not
to overload the transport handle when putting the equipment down.
• The equipment can now be transported using the transport handle.
• The equipment can be parked in minimum space as shown. When parking, put your foot on the axle
to prevent the equipment from rolling away.
TRANSPORT
them, together with the machine head to the same side as the transport wheels, then fasten the two
clamping screws again.
• Fold up the feet one after the other, ideally starting on the same side as the transport wheels so as not
to overload the transport handle when putting the equipment down.
• The equipment can now be transported using the transport handle.
• The equipment can be parked in minimum space as shown. When parking, put your foot on the axle
to prevent the equipment from rolling away.
STORAGE
Store the equipment and its accessories out of the reach of children in a dark, dry place at above
freezing temperature.
The ideal storage temperature is between 5 and 30° C. Store the electric tool in its original packaging.
How?
Visual inspection.
Blow dust and splinters away with compresses air,
or use a brush.
Romove the dust and splinters with a vacuum
cleaner or a brush.
Wipe the deposits away with a cloth.
Let the cooling water out of the water container,
clear water.
How?
Refer to the section "CHANGING THE DIAMOND
CUTTING WHEEL".
Replace the cooling water pipe. (See below)
rst undo the clamping screws and push
rst undo the clamping screws and push
124
FR
ES
PT
IT
EL
PL
UA
RO
EN