Electronic Controller; Dust Extraction; External Extraction - Rupes HSE73 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ELECTRONIC CONTROLLER

Soft start
The soft start is electronically controlled. The soft start guarantees the motor and battery protection and reduces
the risk of injury for the operator.
Speed control
The speed of the tool can be changed by rotating the speed regulation knob (2) to the desired setting.
The speed regulation knob can be set speed for any speed between 7000 and 11000 RPM.
Tool Protections
The electronic protection protects the tool from different events that can damage the tool and create a risk of injury
for the operator. It also guarantees a longer life.
NOTICE: in a case of overcurrent or overheating caused by repeated starts or excessive overloads, the
protection limits the tool power consumption and reduce RPM. If the condition continues, the electronic
protection turns off the tool.
ACCESSORIES ASSEMBLY AND DISASSEMBLY
WARNING: Before (dis)assembling the tool assure that the speed regulation knob (2) is in OFF
position (0 position).
NOTICE: For have the optimal tool performance use only original accessories and consumables.
Sanding Pad
- Place the sanding pad (9) in the center;
- Tighten the sanding pad fixing screw (7). (Fig. 1)
- For disassembly: Unscrew pad's mounting screws (7).
NOTICE: Fitting non-original or incorrect sized backing pads may cause excessive vibration of the tool.
Abrasive Paper
- Used abrasive paper can be removed by simply tearing them off;
- Apply the new abrasive paper by pressing the same on the sanding pad (9), and making sure that the holes on
the paper coincide with suction holes of the pad.
NOTICE: Only Velcro abrasive paper with dust extraction holes is allowed.

DUST EXTRACTION

WARNING: Dust can be hazardous to health. Always work with a dust extractor. Always read
applicable nation regulations before extracting hazardous dust.
INTEGRATED EXTRACTION
- To guarantee optimal extraction of the powder empty the conical filter (8) in time, accurately cleaning the filter
holder (8a) and regularly cleaning the cartridge (8b);
- During works on the vertical surfaces, position the machine so the conical filter is turned downwards.
- Conical filter assembly: position the conical filter (8) on the extractor connector (4). Push the conical filter until it
stops. (Fig. 2)
- Conical filter filling testing: the filling status of the conical filter is easily controlled using the transparent filter
holder (8.a).
- Conical filter cleaning: to empty the conical filter, remove it from the extractor connector;
- Release the cartridge (8b) and release it from the filter holder;
- Empty the filter holder;
- Clean the cartridge plates with a soft brush.

EXTERNAL EXTRACTION

- During vertical surface works position the machine in such a way the extractor tube is turned downwards.
- Assembly: insert an extractor tube on the extractor connector (4) (Fig. 2);
- Connect the extractor tube to an adequate vacuum system.
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hsr73Hss73

Tabla de contenido